Since 2010, graphics cards have been released with either axial fans, or a centrifugal fan also known as a blower, turbo or squirrel cage fan. Some of the higher powered cards can produce more heat than the CPU (dissipating up to 350 watts ), so effective cooling is especially important. These fans were not necessary on older cards because of their low power dissipation, but most modern graphics cards designed for 3D graphics and gaming need their own dedicated cooling fans. Used to cool the heatsink of the graphics processing unit or the memory on graphics cards. The PSU is mainly bottom-mounted in modern PCs, having its own dedicated intake and exhaust vents, preferably with a dust filter in its intake vent.ĪSUS GeForce GTX 650 Ti, a PCI Express 3.0 ×16 graphics card, using two fans for cooling This cycle of increasing temperature and decreased efficiency continues until the PSU either overheats, or its cooling fan is spinning fast enough to keep the PSU adequately supplied with comparatively cool air. Decreased conductivity means that the PSU will convert more of the input electric energy into thermal energy (heat). As the PSU temperature rises, the conductivity of its internal components decrease. The hotter the PSU's intake air is, the hotter the PSU gets. While the power supply (PSU) contains a fan with few exceptions, it is not to be used for case ventilation. Heatsinks are especially vulnerable to being clogged up, as the insulating effect of the dust will rapidly degrade the heatsink's ability to dissipate heat. Air filters are often used over intake fans, to prevent dust from entering the case and clogging up the internal components. Decorative fans and accessories are popular with case modders. As case fans are often the most readily visible form of cooling on a PC, decorative fans are widely available and may be lit with LEDs, made of UV-reactive plastic, and/or covered with decorative grilles. Standard axial case fans are 40, 60, 80, 92, 120, 140, 200 and 220 mm in width and length. Some ATX tower cases have one or more additional vents and mounting points in the left side panel where one or more fans may be installed to blow cool air directly onto the motherboard components and expansion cards, which are among the largest heat sources. Case fans may be placed as intake fans, drawing cooler outside air in through the front or bottom of the chassis (where it may also be drawn over the internal hard drive racks), or exhaust fans, expelling warm air through the top or rear. The components inside the case cannot dissipate heat efficiently if the surrounding air is too hot. Applications įans are used to move air through the computer case. Chassis or case fans, usually one exhaust fan to expel heated air from the rear and optionally an intake fan to draw cooler air in through the front, became common with the arrival of the Pentium 4 in late 2000. Active cooling on CPUs started to appear on the Intel 80486, and by 1997 was standard on all desktop processors. In the IBM PC compatible market, the computer's power supply unit (PSU) almost always uses an exhaust fan to expel warm air from the PSU. A user can even supplement this function with additional cooling components or connect a manual fan controller with knobs that set fans to different speeds. A computer's BIOS can control the speed of the built-in fan system for the computer. Fan control is not always an automatic process. Fans attached to components are usually used in combination with a heat sink to increase the area of heated surface in contact with the air, thereby improving the efficiency of cooling. To cool these components, fans are used to move heated air away from the components and draw cooler air over them. While in earlier personal computers it was possible to cool most components using natural convection ( passive cooling), many modern components require more effective active cooling. Computer fans are powered and controlled using 3-pin or 4-pin fan connectors. Computer fans commonly come in standard sizes, such as 92 mm, 120 mm (most common), 140 mm, and even 200–220 mm. Both axial and sometimes centrifugal (blower/squirrel-cage) fans are used in computers. Fans are used to draw cooler air into the case from the outside, expel warm air from inside and move air across a heat sink to cool a particular component. A 30-millimetre (1.2 in) PC fan laying atop one sized 250 mm (9.8 in)Ī computer fan is any fan inside, or attached to, a computer case used for active cooling.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |